Dynamic response of permalloy/Cu/Co magnetoresistive sandwiches

The dynamic response of trilayer magnetoresistive permalloy/Cu/Co films was studied by high-frequency permeability spectra measurements. The resonance frequency is shown to depend on the interlayer copper thickness. This dependence is related to exchange coupling between permalloy and cobalt and the interaction field is estimated using the Landau–Lifschitz–Gilbert model.     

Directed and elliptic flow in 197Au+197Au at intermediate energies

Directed and elliptic flow for the ¹⁹⁷Au+¹⁹⁷Au system at incident energies between 40 and 150 MeV per nucleon has been measured using the INDRA 4π multi-detector. For semi-central collisions, the excitation function of elliptic flow shows a transition from in-plane to out-of-plane emission at around 100 MeV per nucleon. The directed flow changes sign at a bombarding energy between 50 and 60 MeV per nucleon and remains negative at lower energies. Molecular dynamics calculations (CHIMERA) indicate sensitivity of the global squeeze-out transition on the σ _NN and demonstrate the importance of angular momentum conservation in transport codes at low energies.     

石墨和纳米碳中缺陷和电子密度随温度的变化

测量了石墨和纳米碳在不同温度下的正电子寿命谱,研究了石墨和纳米碳中缺陷和电子密度随温度的变化.结果表明,纳米碳中缺陷的开空间和缺陷浓度分别大于和高于石墨晶体;纳米碳的平均自由电子密度低于石墨晶体.当温度从25K升至295K时,石墨和纳米碳中的平均自由电子密度随温度的升高而下降:石墨晶体中的自由电子密度随温度的升高变化较小;纳米碳的自由电子密度随温度的升高变化较大.随着温度的升高,石墨和纳米碳中的热空位数量增多,而且这些空位可迁移至微孔洞的内表面使微孔洞的开空间增大.     

Annealing effect on soft magnetic properties and magnetoimpedance of Finemet Fe73.5Si13.5B9Nb3Au1 alloy

Effect of annealing on the soft magnetic properties of Fe_73.5Si_13.5B₉Nb₃Au₁ amorphous ribbon has been investigated by means of structure examination, magnetoimpedance ratio (MIR) and incremental permeability ratio (PR) spectra measured in the frequency range of 1–10 MHz at a fixed current of 10 mA X-ray diffraction analysis showed that the as-cast sample was amorphous and it became nanocrystalline under a proper heat treatment. When annealing amorphous alloy at 530 °C for 30, 60, 90 min, soft magnetic properties have been improved drastically. Among the samples investigated, the sample annealed at 530 °C for 90 min showed the softest magnetic behavior. The MIR and PR curves revealed the desirable changes in anisotropy field depending upon annealing.     

Magnetism in electron-doped copper oxides

We report muon spin relaxation/rotation measurements on sintered powder samples of Nd_2−x Ce _x CuO_4−y and a large single crystal of Nd₂CuO_4−y . We find an electronic phase diagram which is quite similar to that of hole-doped superconductors such as La_2−x Sr _x CuO_4−y , although the doping of electrons into the system is less efficient in destroying the static moments on the copper spins. Static magnetic order in Nd₂CuO_4−y appears below about 250 K, and two spin reorientations are seen atT=75 K andT=35 K. Measurements of the magnetic field penetration depth have been unsuccessful due to the rare-earth paramagnetism of these materials.     

μSR studies of heavy fermion systems

We have performed both zero field and high transverse field measurements at dilution refrigerator temperatures on a number of heavy electron systems, examining the superconducting and magnetic properties of these interesting materials. Among the materials studied to date are UBe₁₃, URu₂Si₂ and U₆Fe. The magnetic field penetration depth in the superconducting state of UBe₁₃ is greater than 10000 Å, as no increase in the transverse field relaxation rate is observed belowT _c . A sharp increase in the precession frequency is seen, starting atT _c . This frequency shift shows little temperature dependence at low temperature; we found no clear evidence for unconventional superconductivity in this material. Zero field measurements in URu₂Si₂ show the weak antiferromagnetic transition at 17.5 K. Finally, we we found no clear evidence for unconventional superconductivity in this material. Zero field measurements in URu₂Si₂ show the weak antiferromagnetic transition at 17.5 K. Finally, we have observed relaxation in high transverse field due to the formation of a flux lattice in U₆Fe, a material where the electron effective mass is rather lighter than in other heavy fermion systems. The relaxation exhibits a sharp onset atT _c=3.9 K, and is flat at low temperatures as expected for a conventional superconductor.     

π π andK¯K channel coupling

We investigate the origin of the attraction in theK¯K channel around the threshold by introducing an additional channel to theππ andK¯K channels in a separable potential formalism assuming, in general, no direct interaction in theK¯K channel. To reproduce the features of the data, we find that the threshold of the additional channel is much above thef ₀(975) meson position. We show that this three-channel problem can be reduced to an effective two-channel problem where thef ₀(975) behaves as if it were aK¯K molecule bound by the coupling to the exotic channel. This picture is also supported by the fact that a single pole only, in the complexK¯K momentum plane, is associated to thef ₀(975) meson. Various physical observables, like the decay branching ratio and theK¯K scattering length, are then discussed in an effective two-channel framework.     

Optimum parameters for the generalized ADI method

Summary. In the context of the generalized ADI method, we are concerned with the problem of finding in the set of rational functions r with numerator degree m and denominator degree n an element that minimizes where E,F are disjoint real intervals. By extending a recent analysis by Levin and Saff, we present an explicit formula for choosing the pair (m,n) for given m +n. Furthermore, we provide a characterization of and a Remes type algorithm for its determination. Extensive numerical computations furnish some comparison of with asymptotically optimal solutions based on Fejér-Walsh and Leja-Bagby points. Received September 6, 1996 / revised version received June 30, 1997     

Trefftz,collocation, and other boundary methods—A comparison

In this article we survey the Trefftz method (TM), the collocation method (CM), and the collocation Trefftz method (CTM). We also review the coupling techniques for the interzonal conditions, which include the indirect Trefftz method, the original Trefftz method, the penalty plus hybrid Trefftz method, and the direct Trefftz method. Other boundary methods are also briefly described. Key issues in these algorithms, including the error analysis, are addressed. New numerical results are reported. Comparisons among TMs and other numerical methods are made. It is concluded that the CTM is the simplest algorithm and provides the most accurate solution with the best numerical stability. © 2006 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq, 2007